Speaking of steel plate shot blasting machines, it is actually very common in the construction engineering industry. The layout of the shot blasting machine of the steel plate shot blasting machine is multi-angle. Each part of the state steel is cleaned three-dimensionally and 360 degrees, so that the rust layer, welding slag, oxide scale and dirt on the surface of the steel are peeled off, and a smooth surface with roughness is obtained, and the paint film and the surface of the steel are improved. Adhesion, and improve the strength, capacity and intrinsic quality of steel, and extend its service life.

No matter how good the equipment is, if the operation method is wrong, it will bring a lot of hidden dangers! Although most of the shot blasting machines are very well automated, the inaccurate operation method may also cause other problems! Then for The operation precautions of workers when operating the steel plate shot blasting machine are described below.

1. Check the equipment: check before using the steel plate shot blasting machine to see how its mechanical parts and transmission parts are. If the transmission parts are worn out, there will be hidden dangers. There are also some wear and tear of wearing parts. Register it. If the wear is serious, control it. You can also learn about these aspects to avoid some hidden dangers in later use.

2. Check whether the amount of steel shot of the steel plate shot blasting machine is sufficient? This is also very important.

3. Wear protective tools and so on when operating the steel shot blasting machine. Protective tools are really important. Many people do not wear caps or even goggles during operation. This is very dangerous.

In the actual application process, we must also pay attention to the way of use before we can use the steel plate shot blasting machine. If it is said that there are some problems during the operation and some faults, they must be dealt with in time, and the machine should be shut down for handling. If the failure can not be handled well after the machine is shut down, ask the steel shot blasting machine manufacturer for the situation, and repair according to the actual situation!